The Firing Line Forums - View Single Post - Made something for the Blackhawk to eat today.

Beagle333 · February 9, 2013, 11:50 PM

I made about 300 HPs today, and it took forever with the single cav.
I have never tried making more than a handful at a time before with the singles. I'm definitely dragging a chair out to the casting table the next time I decide to make a pile of these. (Straight isotope 95-2.5-2.5)

And I also made another 300 of these nifty little wadcutters (358432) for the wife's .38 while I was at it. It is a 358432 drilled for a HP pin, (this is actually the "Turtle Buster" mold that I posted here a few month ago) but for this run I put the flat pin in it but didn't pull it all the way down flush, so it left a nice concave nose on 'em instead of a deep hollow point. I kinda like the look.

February 9, 2013, 11:50 PM	#1
Beagle333 Senior Member Join Date: January 7, 2012 Location: Auburn, AL. Posts: 2,332	Made something for the Blackhawk to eat today. I made about 300 HPs today, and it took forever with the single cav. I have never tried making more than a handful at a time before with the singles. I'm definitely dragging a chair out to the casting table the next time I decide to make a pile of these. (Straight isotope 95-2.5-2.5) And I also made another 300 of these nifty little wadcutters (358432) for the wife's .38 while I was at it. It is a 358432 drilled for a HP pin, (this is actually the "Turtle Buster" mold that I posted here a few month ago) but for this run I put the flat pin in it but didn't pull it all the way down flush, so it left a nice concave nose on 'em instead of a deep hollow point. I kinda like the look. __________________ . . . Have a Colt and a smile. Last edited by Beagle333; February 11, 2013 at 10:29 PM. Reason: spellin'