View Single Post
Old September 30, 2009, 06:20 PM   #217
Foxbat
Senior Member
 
Join Date: January 13, 2008
Posts: 367
I don't use the strong mount because I like loading sitting down, and with the press bolted to the bench that gives me perfect height.

I use the bracket that comes with the tray, just mount it differently. I put one screw into the edge of the bench, and below I make a simple L-shaped bracket (actually, a bit more than 90 degrees), and use it for additional support.

I have to tell you - I HATE the way Dillon places its trays. I like mine right next to the turret, so my hand would not need to go far for the bullet. You can see the soft cushion I put at the forward edge of the tray, I rest my hand on it, so pretty much just my fingers move back and forth.

Last picture shows the convenient location of the tray.

Another worthy addition I put under my presses - a rod connecting them to the floor, it gives it that extra degree of stability that is extremely welcome.
Attached Images
File Type: jpg bracket1.jpg (184.3 KB, 982 views)
File Type: jpg bracket2.jpg (190.6 KB, 750 views)
File Type: jpg bracket3.jpg (162.4 KB, 670 views)
Foxbat is offline  
 
Page generated in 0.03605 seconds with 9 queries