|
I,m fairly new to reloading rifle cartridges and lastnight I loaded for a my 22-250 remington 700 for the fist time.Anyway the problem I ran into is that when I load for my pistols I've always seated the bullets by chambering and then backing off .010 to .015 from the rifling.with the 22-250 I could see the rifling marks on the bullets but they wouldn't seat any deeper then where I started?So I went ahead and seated them to spec from my reloading books.Is there an easy way to get this measurement like with my pistols?I'm using remington brass(neck sized only),and 55gr sierra spitzers.Many thanks in advance!! James
------------------
guns don't kill zoborgians,zoborgians kill zoborgians. the farside
|