Thread: Bullet Traps
View Single Post
Old August 23, 2009, 08:02 AM   #5
hornady
Senior Member
 
Join Date: April 6, 2009
Location: SWPA
Posts: 428
I used sand bags and Rail road ties. Sand bags in front to slope the loose sand back to the ties. But I did see. A set up on wheels .it was all welded out of 3/8 steel plate. The opening. Was 3 foot by 3 foot. And tapered back to about 6 inches square . at the rear there was a 6 inch box and a piece angled down to drop the fired bullets on the ground. Nice looking out fit. He had a trailer hitch on it. And said he had used up to 44 Mag lead loads in it. He would just put a bucket under it, and most of the lead ended up in the bucket.
hornady is offline  
 
Page generated in 0.03231 seconds with 8 queries