The Firing Line Forums - View Single Post - Revolver Schematic - H&R Sportsman

Dixie Gunsmithing · January 10, 2016, 10:01 PM

capt14k, I'm not sure that there are any good books with the full info on the take down and assembly. I do know that on these, you have to use slave pins to get the trigger guard and components back into the frame during reassembly. That is the key to their assembly.

I would check Cornell Publications for any reprints of H&R manuals, or look for videos on the 199, etc. About all H&R revolvers work in the same manner, and are assembled the same.

January 10, 2016, 10:01 PM	#9
Dixie Gunsmithing Moderator Emeritus Join Date: April 27, 2013 Location: Ohio Posts: 1,923	capt14k, I'm not sure that there are any good books with the full info on the take down and assembly. I do know that on these, you have to use slave pins to get the trigger guard and components back into the frame during reassembly. That is the key to their assembly. I would check Cornell Publications for any reprints of H&R manuals, or look for videos on the 199, etc. About all H&R revolvers work in the same manner, and are assembled the same.