View Single Post
Old April 21, 2006, 04:51 PM   #2
cntryboy1289
Senior Member
 
Join Date: July 19, 2004
Location: Ms
Posts: 1,160
info for you

This extractor is held in place by a plunger and spring. You need to use something to push the plunger to the rear of the bolt and then push the extractor out of the bolt from front to back. To put it back in, I use my fingers, but you may need to use whatever tool you used to push the plunger to the rear so you can slide the extractor back in. There will be a hole that is drilled into the bolt to the rear for the spring and plunger and one drilled cross ways that the tail of the extractor will fit in. Just slide the tail and and then the extractor back and let he plunger move forward to hold it in place. Hope this helps.
cntryboy1289 is offline  
 
Page generated in 0.02200 seconds with 8 queries