The Firing Line Forums - View Single Post

Garycw · April 20, 2013, 06:03 PM

Tennjed, the best thing I've found for polishing stainless steel in Semi-Chhrome. ..BY HAND!
You can find it at some cycle shops or eBay. Works great on all types of metals.
As far as Dremels, I've mainly used on feed ramps with felt point , coarse then fine rouge. Polishes to mirror finish. I use dremel hung up, connected to a speed control foot pedal with a flex shaft from dremel accessories.
Most everything else its better by hand IMO.

April 20, 2013, 06:03 PM	#16
Garycw Senior Member Join Date: May 27, 2011 Location: Ohio-Kentucky - florida Posts: 1,221	Dremel question for polising slide Tennjed, the best thing I've found for polishing stainless steel in Semi-Chhrome. ..BY HAND! You can find it at some cycle shops or eBay. Works great on all types of metals. As far as Dremels, I've mainly used on feed ramps with felt point , coarse then fine rouge. Polishes to mirror finish. I use dremel hung up, connected to a speed control foot pedal with a flex shaft from dremel accessories. Most everything else its better by hand IMO.