The Firing Line Forums - View Single Post

Skans · October 9, 2013, 01:29 PM

Is there any way to fill the hole and and re-tap it? I'm wondering if a metal insert can be pressed into that hole if its widened out a bit?

(W-n-C must have been writing the same time I was, but beat me to the punch!

)

October 9, 2013, 01:29 PM	#9
Skans Senior Member Join Date: November 20, 2008 Posts: 11,132	Is there any way to fill the hole and and re-tap it? I'm wondering if a metal insert can be pressed into that hole if its widened out a bit? (W-n-C must have been writing the same time I was, but beat me to the punch!)