The Firing Line Forums - View Single Post - Resizing - FL, NK, Lee Collet, FL bushing

HJ857 · February 20, 2013, 05:17 PM

Sorry, I wasn't clear about it. I do mean brass that has gone through both sizing operations.

I've been meaning to do this myself but as you stated, I haven't seen a need to go further than just the Collet die since it works so well by itself. However, I am still very curious about it.

I have a RCBS FL die but the decapping pin broke on exactly the third piece of brass I ran through it. I was so PO'ed that I took it off the press and have not put it back on. I guess it's time to do so!

February 20, 2013, 05:17 PM	#19
HJ857 Senior Member Join Date: January 9, 2007 Posts: 447	Sorry, I wasn't clear about it. I do mean brass that has gone through both sizing operations. I've been meaning to do this myself but as you stated, I haven't seen a need to go further than just the Collet die since it works so well by itself. However, I am still very curious about it. I have a RCBS FL die but the decapping pin broke on exactly the third piece of brass I ran through it. I was so PO'ed that I took it off the press and have not put it back on. I guess it's time to do so!