View Single Post
Old May 11, 2009, 10:30 PM   #5
madcratebuilder
Senior Member
 
Join Date: November 2, 2007
Location: Northern Orygun
Posts: 4,923
Quote:
I think the 1860 has two screws(around the hammer on eithe side) that allow you to remove and put grease in them.
If your talking about the four screw models those are for supporting the shoulder stock. I suppose you could pack grease in the frame, although shoulder stocks fit the three screw repros fine. I have been lucky and have only had one open top break a hand spring. I drilled the frame and use a Ruger plunger and spring to apply forward pressure on the hand. That eliminates the problem.
Welcome to the forum, there's another 'smokin gun' screen name here, keep an eye on your whiskey when he's around.
madcratebuilder is offline  
 
Page generated in 0.03854 seconds with 8 queries