The Firing Line Forums - View Single Post

oneoldsap · November 18, 2012, 11:40 AM

I didn't see anywhere where you trimmed all brass to the same length . It's important to have all brass the same length , when neck sizing . I usually trim brass that I'm going to neck size , .010" shorter than recommended trim to length in the manuals . Depending on a few variables , you should be able to get 5-10 reloads before needing to trim again !

November 18, 2012, 11:40 AM	#5
oneoldsap Senior Member Join Date: September 16, 2009 Location: I live in the foot of the Green Mountains of Vermont Posts: 1,602	Uniformity I didn't see anywhere where you trimmed all brass to the same length . It's important to have all brass the same length , when neck sizing . I usually trim brass that I'm going to neck size , .010" shorter than recommended trim to length in the manuals . Depending on a few variables , you should be able to get 5-10 reloads before needing to trim again !