Thread: SXS Question
View Single Post
Old October 25, 2008, 11:41 AM   #1
vitesse9
Senior Member
 
Join Date: November 9, 2004
Posts: 340
SXS Question

I have a stoeger coach gun. It's actually the second one because the first had to go back to the factory and was replaced.

On the first one, the right bbl was dead on, but the left bbl was about 2.5 inches high and 2.5 inches left. Sent the first gun back and Stoeger sent a new one.

On the second one, the right bbl is dead on on elevation and about 2 inches right on windage. The left bbl is about 1 inch high in elevation and about two inches left in windage. All patterning was done at 15 yards.

BTW, these are the supreme models and thus have chokes. I went out and purchased two IC aftermarket chokes of the same brand and patterning was about the same.

This is my first SXS. I guess I expected windage to be a little different becasuse the bbls are, well, side by side. However, I'm concerned about the difference in elevation b/w the two bbls (left bbl is about an inch higher at 15 yards).

Any thoughts?
vitesse9 is offline  
 
Page generated in 0.03460 seconds with 8 queries