View Single Post
Old March 7, 2010, 12:53 PM   #5
croc4
Senior Member
 
Join Date: March 9, 2006
Location: Idaho
Posts: 191
its a 6.8spc shooting reloads, its an after market jard trigger, went through the instructions again yesterday, seems to per their instructions. I also noticed with only the bolt head and the firing pin, that the firing pin tends to stick in the bolt head depending on where the pin is rotated, some times it will drop out other times it seems to stick enough that it won't drop out when the the bolt head is facing up, so this could be the problem. The firing pin should always drop out when you face the bolt head up correct?


croc4
croc4 is offline  
 
Page generated in 0.02456 seconds with 8 queries