View Single Post
Old October 11, 2012, 10:05 PM   #1
willhud
Member
 
Join Date: September 4, 2012
Posts: 60
GSG 1911-22 (ATI/Sig)

I am not sure if this is the right forum, but I am wondering if someone can help me with removing/changing the front sights on the pistol. It comes with two additional sites. The manual says to turn the screw in the front site counter clockwise. It comes with a small tool kit that has three allen wrenchs. The two larger ones are too big for the hole. The smaller one fits into the hole, but I have turned and turned and turned that allen wrench and it doesn't seem to be loosening the screw. I think it's actually too small. Do anyone know what size screw driver or allen wrench I should be using. The screw is sticking up on the extra sites, but I have never seen a screw like this. It isn't like it has a hex head or a phillips or flat head.

Any help you can give me is greatly appreciated.
willhud is offline  
 
Page generated in 0.02601 seconds with 8 queries