View Single Post
Old September 17, 2009, 01:43 PM   #2
10-96
Senior Member
 
Join Date: October 19, 2005
Location: Tx Panhandle Territory
Posts: 4,159
If you've gotten the screw-on cap off- then don't take the inner spring cap thing out. Just use a wooden dowel rod cut to length or a pencil. You can buy the fancy plastic plug- and that will sit on top of the spring cap thing.

However, if you can't get the screw-on cap off- then yes, you may need to wrap your channel lock plier jaws with several layers of duct tape. They make special padded jawed pliers just for this job- but why pay $20+ for something you won't use that often?
__________________
Rednecks... Keeping the woods critter-free since March 2, 1836. (TX Independence Day)

I suspect a thing or two... because I've seen a thing or two.
10-96 is offline  
 
Page generated in 0.03443 seconds with 8 queries