PetahW
Quote:
|
Does the rifle have the correct size RR ? (diameter)
|
Ram rod is its original.
Nothing in the channel that I can see. Just a long rudimentary drilled hole. The R-R tensioning spring is fastened to the bottom of its barrel rib very close to its R-R entrance hole into the stock. Not that much tensioning on that little piece of spring steel do I feel/see with its R-R installed. As far as a channel light. I don't have anything to slide/fit down into its 3/8s hole. Got bore lights but nothing that small to do the job with. {got any suggestion for a reflection tool?}
Wooden R-R doesn't appear warped. The drill that the factory uses to bore out a channel with. Would it be like what an electrician uses to drill thru wall plates to string door bell wire thru/with? {foot or better shaft length on some bigger bit sizes I've noticed at my Home Depot.} One thing I haven't done with this rifle. Its been in storage a long long time. wo/ its R-R attached. If that means anything?