View Single Post
Old December 2, 2011, 09:39 AM   #4
243winxb
Senior Member
 
Join Date: July 26, 2011
Location: USA
Posts: 1,730
Outside Neck Turning for Factory Chambers

Quote:
Is neck turning for factory stock rifles worth the added work?
Only if you do all benchrest prep of the brass. Use Fl sizing bushing dies & size only 1/2 of the neck, allowing the unsized part to center the round in the chamber. Takes about 3 firings in both of my 243win, Rem factory riflles. Turn some brass, load with standard dies, you might ever see an imporovement with this method, but best to sort the brass by weight after preping. Watch neck tension.

Last edited by 243winxb; December 2, 2011 at 09:46 AM. Reason: added Turn some....................
243winxb is offline  
 
Page generated in 0.02199 seconds with 8 queries