[mjrodney]

My Lee single stage has a slot in the ram (priming arm removed) that allows the occasional spent primer to fly out during the sizing and decapping of the case.

This flying primer would always fail to hit the trash can I keep below the press.....until, that is, I tacked a small hand towel on the edge of the bench and led the other end of the towel into the trash can.

Now, most of the flying primers hit the towel and roll merrily along until they reach the can.

This probably doesn't seem important until you walk barefoot through the garage one day and impale your heel onto a spent primer.

You jump around fast enough to be chronographed.