View Single Post
Old November 10, 2011, 06:39 PM   #1
Punkwood2k
Junior Member
 
Join Date: November 3, 2011
Posts: 5
Case trimming on .45 ACP?

I searched but couldnt find an answer for this.. sorry if its a repost...

I've read everywhere that rifle cases need to be trimmed for proper length because of lengthening of the neck..

But when it comes to straight walled cases for handguns, like my .45 ACP, I've read both ways. That you need to check for length and trim, and that straight case handgun loads dont need to be checked for case length / trimmed ever?

Which way is the truth? I dont want to invest in a case trimmer unless I have to at this point, and .45 & 9mm are the only loads I am doing to start with..
Punkwood2k is offline  
 
Page generated in 0.02327 seconds with 8 queries