View Single Post
Old May 15, 2009, 09:44 PM   #37
madcratebuilder
Senior Member
 
Join Date: November 2, 2007
Location: Northern Orygun
Posts: 4,923
IMHO you should only have to use firm thumb pressure to seat the wedge. I don't believe in using the wedge to adjust the barrel/cylinder gap as some do. I believe the gap is controlled by the frame, barrel lug and arbor fit. If your using the wedge to close up the gap your tilting the barrel up. Most of the revolvers I have bought required work in the area to make them fit correct. Once that is accomplished you should not have any problems with the wedge.
madcratebuilder is offline  
 
Page generated in 0.03365 seconds with 8 queries