OK. New brass and now a new problem. I just got some speer nickel plated brass in. I got my crimp and bullet tension worked out. However I think this brass might.be thicker and causing problems. The other brass casings I loaded were. 331 after loaded. These are .335 and are getting stuck in the chamber. I'm using almost zero flare and very little crimp. Is it just thicker brass? Is there anything I can do about it? Thanks
Edit.....changed my COAL down to. 907 from. 925 now they will fall back out if the barrel under their own weight. But why? The other brass I loaded at. 925 fell back out just fine. But these don't. Case length is the same on both the brass and nickel cases.
Last edited by motoman202; February 13, 2013 at 09:28 PM.
|