View Single Post
Old January 13, 2013, 12:01 PM   #3
Brian Pfleuger
Moderator Emeritus
 
Join Date: June 25, 2008
Location: Austin, CO
Posts: 19,578
I use Lizard Litter and a shot of Flitz polish. Works as good as you can expect without going to wet, stainless pins or ultrasonic.

You add the polish and let it run until it mixes well. Add the brass and run a few hours. Doesn't clean innards or primer pockets.

Adding pieces of used fabric softener sheets picks up the dirt and helps keep the media useable longer.
Brian Pfleuger is offline  
 
Page generated in 0.03382 seconds with 8 queries