View Single Post
Old October 29, 2013, 07:25 PM   #20
Jeff2131
Senior Member
 
Join Date: November 30, 2012
Location: Spring City, PA
Posts: 497
Unclenick, you maybe be right, because when it snapped my decapping pin i threw it in the trash so i never did get the primer out to see if it had two flash holes. Makes sense. I never use 5.56 or 7.62 so i just assumed that the four little dents around the primer meant it was crimped and that if i tried to run in through my die it would snap my pin. With that being said, i dont own a reamer or decrimper tool....i thought they were used BEFORE decapping to cut out those four little dents...hahaha.

Again, being schooled by you guys is great, i keep learning everytime i post or make a comment. Thanx!
__________________
---I DON'T DIAL 911---
Jeff2131 is offline  
 
Page generated in 0.02524 seconds with 8 queries