The Firing Line Forums - View Single Post

Doug Bowser · June 19, 2012, 11:19 AM

I have a Replica Arms 2nd Model Dragoon by Uberti. It functions well until the trigger is pulled. Then the cylinder lock jumps out of the cylinder lock notches and the cylinder turns slighly before the hammer hits the ege of the notch cut out for the nipples. I bought a new cylinder stop and it does not fit. Should I check how much the bolt stop sticks above the frame? I have replaced a broken sear spring and I have the bolt stop part of the spring exerting a lot of pressure on the bolt stop. What would be my next step? Can I safely grind off the top of the bolt stop leg and allow the bolt stop to rise higher out of the frame?

Doug

June 19, 2012, 11:19 AM	#1
Doug Bowser Senior Member Join Date: May 6, 2005 Posts: 163	Trouble with C&B Dragoon I have a Replica Arms 2nd Model Dragoon by Uberti. It functions well until the trigger is pulled. Then the cylinder lock jumps out of the cylinder lock notches and the cylinder turns slighly before the hammer hits the ege of the notch cut out for the nipples. I bought a new cylinder stop and it does not fit. Should I check how much the bolt stop sticks above the frame? I have replaced a broken sear spring and I have the bolt stop part of the spring exerting a lot of pressure on the bolt stop. What would be my next step? Can I safely grind off the top of the bolt stop leg and allow the bolt stop to rise higher out of the frame? Doug