View Single Post
Old September 19, 2010, 11:53 PM   #13
JR_Roosa
Senior Member
 
Join Date: January 27, 2009
Posts: 130
A middle option between neck sizing only and full length sizing is to get a RCBS or Hornady case gauge and set up your die to resize just enough to fit the chamber. You will completely size the neck, size the body a little, and hold the shoulder right where you want it. This way every batch you make is exactly the same. None will get tight in the chamber and you won't have a batch every now and then that is fully resized that needs to be re-fireformed.

Test a batch of each in your rifle and see what gives the best results.

-J.
JR_Roosa is offline  
 
Page generated in 0.03709 seconds with 8 queries