View Single Post
Old June 13, 2013, 08:36 PM   #2
res45
Senior Member
 
Join Date: September 15, 2007
Location: NC
Posts: 751
It can be done but you will need to resize the case neck for proper bullet tension. Don't really see the point in doing so just to replace the powders unless there is an issue with it.

I've done this on occasion many years ago when there was no available reloadable brass but I used the existing powder with some modifications to the powder charges and only replacing the factory FMJ with a equal or less weight SP in same dia. or slightly less to make hunting ammo.
res45 is offline  
 
Page generated in 0.03102 seconds with 8 queries