Thread: Lubing Bullets
View Single Post
Old July 14, 2001, 07:15 AM   #1
Point Blank
Senior Member
 
Join Date: October 25, 2000
Location: Armpit of the South...Atlanta
Posts: 516
Lubing Bullets

I am using the Lee load all (one at a time) kit.Since i am trying to achieve the best accuracy available using this "primitive" method, should i slightly lube the inside of the case neck or bullet???If so,will Rem. oil or CLP do?? Or am i completly confused and lubing the case is done while resizing to relieve stress on the brass. I read somewhere that lubing the bullet slightly reduces the friction of the bullet as it leaves the case,resulting in better accuracy.Thanks for any replies..
Point Blank is offline  
 
Page generated in 0.03170 seconds with 8 queries