round, thick shaving rings. I'm guessing .451s would go in with very thin shavings. But don't have any around to try.
As for the above discussion--Couldn't one just measure the chambers?
I couldn't because I don't think my dial caliper is accurate enough. But a smart guy with a micrometer or something?
Speak of the devil, i think my Pietta Rem. NA is a little camfered... it doesn't shave any .454 lead but it's the most accurate of my NAs.
Quote:
Did you get a hand spring made or one to work on the Navy? Come on up I got some feeler gauge stock I'll make you one...and I think the Uberti hand will work...I had made one for my Uberti Na
|
thanks, I matched the new handspring to the original and it works fine.