The Firing Line Forums - View Single Post

FrankenMauser · April 21, 2011, 01:25 AM

I recently installed a Wolff spring kit in my .327 BH, have a SBH Hunter (stainless) hammer on the way for the .327, and will probably be ordering another spring kit for my .44 Mag SBH. I considered stoning the .327, but figured I'd wait for the new hammer (and I find it helpful to see how the trigger and hammer are "wearing in" and contacting each other, after some use). The SBH is well worn, and thoroughly broken it. It just needs some springs.

They're perfectly serviceable revolvers from the factory, but a few springs can make things that much better.

April 21, 2011, 01:25 AM	#7
FrankenMauser Senior Member Join Date: August 25, 2008 Location: In the valley above the plain Posts: 13,424	I recently installed a Wolff spring kit in my .327 BH, have a SBH Hunter (stainless) hammer on the way for the .327, and will probably be ordering another spring kit for my .44 Mag SBH. I considered stoning the .327, but figured I'd wait for the new hammer (and I find it helpful to see how the trigger and hammer are "wearing in" and contacting each other, after some use). The SBH is well worn, and thoroughly broken it. It just needs some springs. They're perfectly serviceable revolvers from the factory, but a few springs can make things that much better. __________________ Don't even try it. It's even worse than the internet would lead you to believe.