View Single Post
Old April 8, 2014, 11:27 PM   #25
nanewt02
Senior Member
 
Join Date: February 25, 2013
Posts: 249
Minus the grooves and locking indentation in the cylinder pin, it is about done. it steps down from .250 to .2165 where it runs through the cylinder. with alittle lubrication the cylinder now turns smoothly. besides fitting the barrel and setting the cylinder gap, the revolver is about ready for bluing. you can see the file marks where the dents on the sideplate were removed and the sideplate seam is virtually gone. The cylinder axle/pin will be flush with the front of the barrel and will also serve as a handy cleaning rod.
nanewt02 is offline  
 
Page generated in 0.04322 seconds with 8 queries