View Single Post
Old September 25, 2008, 01:04 PM   #4
Casimer
Senior Member
 
Join Date: April 23, 2007
Location: Pennsylvania, USA
Posts: 1,918
Quote:
If your moon clip is bent, pitch it.
I agree. But I doubt that any moonclip is going to be as flat as a machined cylinder face. That's basically my concern - they're probably all bent , or uneven, to some degree. But does this affect the revolver's accuracy, or does the clip bend under the force of the hammer so that the headspace of each cartridge is effectively the same for each chamber?
Casimer is offline  
 
Page generated in 0.02315 seconds with 8 queries