View Single Post
Old December 25, 2010, 01:54 PM   #1
MosinM38
Senior Member
 
Join Date: August 23, 2007
Posts: 1,030
Double-ringing a scope behind turret.

Okay I got a question for the experts, I couldn't find any so I came here. ( Just kidding).

My question, I've got a picatinny rail that doesn't go quite far enough forward to mount some scopes.

The scope(s) I plan on using are short, straight tubes, no forward bell.

My question is, can I install two rings behind the adjustment turrets (Or three rings if there is room), and leave the section of tube ahead of the turrets unsupported?

I know having two (or three) rings behind the turret is not as good as one in front and one in back. But is it actually BAD?

With that much supporting area, it should be good enough....shouldn't it?

I appreciate any responses, as this I really don't know.

Thanks.
MosinM38 is offline  
 
Page generated in 0.02401 seconds with 8 queries