The Firing Line Forums - View Single Post - how do you convert lee pro 1000 to 4 hole turent

autotech6 · February 12, 2009, 10:48 PM

Thanks for the response, I was not sure so I thought that I might ask. Do you think that I could get a taper die and use it in a seperate turant in the last position on the press and do the same thing? This of course after the first three steps then go back and do the taper. Any advise would be helpful thanks again.

February 12, 2009, 10:48 PM	#3
autotech6 Junior Member Join Date: January 3, 2009 Location: Colorado Springs Co. Posts: 12	Thanks for the response, I was not sure so I thought that I might ask. Do you think that I could get a taper die and use it in a seperate turant in the last position on the press and do the same thing? This of course after the first three steps then go back and do the taper. Any advise would be helpful thanks again.