View Single Post
Old January 23, 2013, 05:58 PM   #5
TonyAZ
Member
 
Join Date: January 23, 2013
Location: Northern Arizona
Posts: 15
More info and photos

Thanks to Webleymkv--measured as you specify, full lock up, the cylinder gap is still 0.011". Yes it is a nickel finish, not chrome; my slip.

Thanks to Duke City Six--I attach photos, having benefitted much from your pointer to the forum info section.

I attach (I hope) two photos of the model 19. One general shot, and one of the breech end of the barrel. Is the "forcing cone" the slightly tapered first mm or two of the barrel? Is the weak point where the metal is thinner because of the flat cut into the bottom of the barrel?
Attached Images
File Type: jpg IMG_2282-sm1.jpg (204.1 KB, 135 views)
File Type: jpg IMG_2288-sm.jpg (45.4 KB, 97 views)

Last edited by TonyAZ; January 23, 2013 at 06:30 PM. Reason: typos
TonyAZ is offline  
 
Page generated in 0.02451 seconds with 9 queries