Thread: 8mm mauser vz24
View Single Post
Old September 20, 2012, 11:59 AM   #10
rich s
Junior Member
 
Join Date: September 16, 2012
Posts: 11
mauser refitting

Thank You all - you have been very generous with your time and information.
If I could turn back the clock and leave the rifle alone I would certainly do that but did have the bolt altered and a scope mounted all those years ago.
I still am not sure about ordering the barrel ( big disappointment about them coming white ). My main question is about the new .308 barrel bottoming up on the C ring - I have not found a supplier who states that their ' short chambered - lathe free " barrel will torque up properly. My fear is screwing in the new barrel and having it bottom on the receiver.
rich s is offline  
 
Page generated in 0.03684 seconds with 8 queries