|
It was not too bad. I had to remove the metal plate from the wood stock, and that opened up a lot of space. After that on the side of the mag that has the flat spring on it, I had to grind off the plastic, about 1/4 inch. Then I put some epoxy over the gray to clear junction and they worked great. I stopped using them when I got a boyds evolution stock since I am not about to start cutting that thing up! Now they are relegated to the 795 which functions great with them. Another thing you may want to know too, is my accuracy greatly increased with the new stock. Huge. But the length of pull is shorter, darn near uncomfortable. The evolution stock floats the whole barrel out unsupported. Even though it has a sporter barrel and not the varmit, or bull barrel, the accuracy has been phenominal.
|