View Single Post
Old May 23, 2012, 12:26 AM   #4
Sport45
Senior Member
 
Join Date: May 25, 1999
Location: Too close to Houston
Posts: 4,196
The old RCBS dies had the decapper in the expander die. At least my .357 set was like that until I broke the pin. They sent me a conversion kit that put the decapper on the sizing die as a warranty repair.

The second set of steps you list is correct if you have one of the older RCBS dies.

Call RCBS. They'll probably set you up with the conversion.
__________________
Proud member of the NRA and Texas State Rifle Association. Registered and active voter.
Sport45 is offline  
 
Page generated in 0.02684 seconds with 8 queries