The Firing Line Forums - View Single Post

2ndchance · November 9, 2008, 03:08 AM

I'm planning on refinishing my Sig P225/P6 slide. I would like to break the slide town and remove everything so I end up with a gutted/hollowed-out slide. So, here's my question.

1. When drifting the sights off the slide, does it matter which way I tap them (left or right)?

2. When I press out the roll pin in the back, will this allow the entire underside (holding the firing pin and breech face) slip out or is there something else in there holding onto it.

November 9, 2008, 03:08 AM	#1
2ndchance Senior Member Join Date: March 21, 2008 Location: Glendale, AZ Posts: 180	total disassembly of a SIG slide I'm planning on refinishing my Sig P225/P6 slide. I would like to break the slide town and remove everything so I end up with a gutted/hollowed-out slide. So, here's my question. 1. When drifting the sights off the slide, does it matter which way I tap them (left or right)? 2. When I press out the roll pin in the back, will this allow the entire underside (holding the firing pin and breech face) slip out or is there something else in there holding onto it.