The Firing Line Forums - View Single Post

sinter · June 28, 2013, 05:48 AM

Dickttx,

thank you so much for the information, that was exactly what I needed to hear, that I wasn't the only one who couldn't get the 1.125 overall length with the IDP #6. Also I was very concerned that seating the bullet that far down into the case would cause an overpressure situation. Looking at the load data for HP 38 versus Universal's Clay, it appears that there comparable powders. You've given me the confidence to proceed with test firing the 5 grain load seated to the cannulure. Thanks again for the info.

June 28, 2013, 05:48 AM	#5
sinter Junior Member Join Date: May 26, 2012 Posts: 4	Dickttx, thank you so much for the information, that was exactly what I needed to hear, that I wasn't the only one who couldn't get the 1.125 overall length with the IDP #6. Also I was very concerned that seating the bullet that far down into the case would cause an overpressure situation. Looking at the load data for HP 38 versus Universal's Clay, it appears that there comparable powders. You've given me the confidence to proceed with test firing the 5 grain load seated to the cannulure. Thanks again for the info.