View Single Post
Old August 3, 2012, 10:18 PM   #1
xxxleafybugxxx
Senior Member
 
Join Date: December 30, 2011
Posts: 213
Confusion about crimping...

I bought my lee 4 die set for .45 acp, which came with the factory crimp die. I see most people say they don't use this, but only under certain circumstances. This is what came in my kit, therefore, this is what I use. I have cast bullets on the way, but all I have loaded thus far have been plated bullets. Is there a change in method for crimping cast from plated because of the ridges in the slug? Thanks in advance for clearing this confusion!
xxxleafybugxxx is offline  
 
Page generated in 0.03553 seconds with 8 queries