View Single Post
Old October 19, 2010, 07:28 PM   #5
James K
Member In Memoriam
 
Join Date: March 17, 1999
Posts: 24,383
No, you did it the only way you could, but of course you now may have to get or make a new wedge to keep the barrel in the right position. You might have had to drill the holes for the pins deeper, but that seems to have worked OK.

I will join those who saw nothing wrong with the original gap; I consider .007" about ideal in a modern revolver but the factories usually consider .010" to be within spec.

Another issue, though. In discussing a tight b/c gap in revolvers (old or new), most people focus on fouling. But another problem is heat. After firing rapidly, a cylinder heats up and expands lengthwise. If the b/c gap is too tight, the gun will bind up until the cylinder cools down. And yes, even a fast six shots from a c&b revolver can do that if the gap is too tight.

Jim
James K is offline  
 
Page generated in 0.02222 seconds with 8 queries