View Single Post
Old November 20, 2013, 02:06 PM   #2
zippy13
Senior Member
 
Join Date: August 23, 2008
Location: SoCal
Posts: 6,442
You don't have to reduce the trigger pull to eliminate the "crummy" feel. Polishing existing parts may give you a smooth pull. Or, send the trigger group to a trigger guy and specify your desired pull.

Changing out the MIMed cast parts for machined ones is a good idea unless the new parts aren't finished as well as the original ones -- That's a no brainer.

Since I don't use (or trust) trigger block safeties, I wouldn't consider a fat head. If anything, I'd plug the hole and rely on safe gun handling. YMMV.
zippy13 is offline  
 
Page generated in 0.03766 seconds with 8 queries