View Single Post
Old September 19, 2010, 01:46 PM   #2
dagger dog
Member
 
Join Date: September 5, 2010
Posts: 65
Ape,

I assume you are shooting a bolt or non-auto loader, if so this is the way it works

Put your case in the shell holder, make sure the die is backed all the way out where it just makes contact with the case mouth, raise the handle, screw the die in 1/2 turn and run the case into the die then raise the handle again and inspect the case, you will see a "ring" where the die has made contact with and sized the case neck, keep repeating and you will se the "ring" move down the neck toward the shoulder, make sure to stop before the ring makes contact with the shoulder and lock the die down. You may have to adjust the decap ,sizer stem, to make sure it sizes the inside of the neck on the stroke, and you may want to decap on a seperate step.

A better name for this procedure is partial full length resizing. As you shoot these cases they may get hard to close the bolt, and you will have to give them a full size go round if this happens
dagger dog is offline  
 
Page generated in 0.01914 seconds with 8 queries