The Firing Line Forums - View Single Post

Chris_B · April 25, 2010, 04:00 PM

Well, I figured .125" since the 1/8" roll pin was a little tight

Good suggestion on the drill bit shank. I'm sure I have a dull one somewhere that deserves no better fate!

April 25, 2010, 04:00 PM	#4
Chris_B Senior Member Join Date: February 9, 2007 Posts: 3,101	Well, I figured .125" since the 1/8" roll pin was a little tight Good suggestion on the drill bit shank. I'm sure I have a dull one somewhere that deserves no better fate!