View Single Post
Old April 30, 2012, 12:27 PM   #1
deerslayer303
Senior Member
 
Join Date: January 10, 2011
Location: Leesville SC
Posts: 2,652
Half Cock, Full Cock, No Cock

Ok I was reading in another thread and I just have to ask. In order to prevent turn lines, you should always go to full cock from half cock, then let the hammer down. Is this correct? I hope so cause thats the way I do it. My ROA has some turn lines on the cylinder, but they were there when I bought it.
__________________
"I prefer dangerous freedom over peaceful slavery."
- Thomas Jefferson
deerslayer303 is offline  
 
Page generated in 0.03274 seconds with 8 queries