The Firing Line Forums - View Single Post - SKS

GRCummins · March 31, 2013, 11:45 AM

Thanks HJ, the trigger assembly area is exactly where I see the problem to be. No doubt I want it to be tight fit, but I have 3/16" to 1/4" of shaving to get the back end of the receiver to be able to meet the trigger assembly.
I just wanted to get clarification from others with experience before I start manipulating my new stock.
I was also experiencing difficulty removing the pin at the hand guard area. Any thoughts on that so that I dont destroy the gas tube?
Thanks for your input.
Greg

March 31, 2013, 11:45 AM	#5
GRCummins Junior Member Join Date: March 24, 2013 Location: Norfolk, VA Posts: 5	Thanks HJ, the trigger assembly area is exactly where I see the problem to be. No doubt I want it to be tight fit, but I have 3/16" to 1/4" of shaving to get the back end of the receiver to be able to meet the trigger assembly. I just wanted to get clarification from others with experience before I start manipulating my new stock. I was also experiencing difficulty removing the pin at the hand guard area. Any thoughts on that so that I dont destroy the gas tube? Thanks for your input. Greg