The Firing Line Forums - View Single Post - .300 WSM and .257 Roberts Reloading Questions

PCB2054 · August 1, 2011, 06:54 PM

Sounds like tomorrow I will screw the die in a little tighter and make sure the cases are lubed well. If this does not work then I will try and grind a few thousands off the top of the shell holder. I appreciate the suggestions fellas!
As for my brothers rifle it is a 1-10 twist. In my opinion he should go with a smaller bullet and start with a small load and work his way up. whats your opinion? Thanks again fellas this forum has been helpful!

August 1, 2011, 06:54 PM	#8
PCB2054 Junior Member Join Date: July 31, 2011 Posts: 4	Thanks Fellas Sounds like tomorrow I will screw the die in a little tighter and make sure the cases are lubed well. If this does not work then I will try and grind a few thousands off the top of the shell holder. I appreciate the suggestions fellas! As for my brothers rifle it is a 1-10 twist. In my opinion he should go with a smaller bullet and start with a small load and work his way up. whats your opinion? Thanks again fellas this forum has been helpful!