View Single Post
Old February 14, 2009, 10:16 PM   #2
James K
Member In Memoriam
 
Join Date: March 17, 1999
Posts: 24,383
It sounds like you really have a tight ("target") chamber but if factory rounds fit OK, and it passes the GO gauge, I don't think the rifle is at fault.

I think you have a resizing die that is not resizing quite enough. (Remember, loading dies have their own tolerances, and sometimes the tolerances "stack.")

Try calling the die manufacturer and asking about a tight die or an auto rifle die; the latter are generally smaller because auto rifles often have little seating power.

Jim
James K is offline  
 
Page generated in 0.02500 seconds with 8 queries