View Single Post
Old June 23, 2002, 04:00 PM   #1
RAThomas
Senior Member
 
Join Date: October 9, 1999
Location: Olathe, KS USA
Posts: 129
Powder pan problem

I use a RCBS Powdermaster electronic power dispenser and digital scale to throw and measure my loads. Although it is a little slow, I like the system. One problem I am having is that sometimes the dispenser will not throw the selected load and I empty the scale pan back into the dispenser. This is the problem: not all of the powder will empty from the pan. Knocking the pan against the hopper will dislodge it and the pan is empty. However, this dribbles some powder from the dispenser onto the scale. It seems as if what I put back into the hopper is offset by what comes from the despenser.

Question: Back a long time ago I read that putting liquid soap on the pan and not wiping it off would help to keep the powder from sticking. Any comments or suggestions?
RAThomas is offline  
 
Page generated in 0.02722 seconds with 8 queries