View Single Post
Old December 6, 2012, 12:17 PM   #34
F. Guffey
Senior Member
 
Join Date: July 18, 2008
Posts: 7,249
"If you have an actual "Go-gauge", you should be using that to set the barrel to minimum and then you can set your dies the exact same way. Run gauge into the press, screw the die down until it touches the gauge, remove the gauge and screw the die down another .001."
__________________

If a gage has been used as a transfer to adjust the die to and or off the shell holder the the person doing the transfer/adjustment would have notice the go-gage will be prevented from being used because of the primer punch/sizer plug assemble and the shell holder may not accept the gage.

F. Guffey
F. Guffey is offline  
 
Page generated in 0.03427 seconds with 8 queries